Awesomatix EP Touring Car (A700 Shaft Drive)
#9871
#9872
#9873
![Default](https://www.rctech.net/forum/images/icons/icon1.gif)
See you all at the track very soon...I will be testing my bumper and other designed parts....PEACE !!!
#9875
#9881
![Default](https://www.rctech.net/forum/images/icons/icon1.gif)
The a13W adapters are only 1mm wider, and the hubs are not wide enough, also causing the cvd's to be too short...I have not seen a single A700 with 189mm track width on the internet...Not to mention the cost of all these parts...Solution: Bert mods.....Stay tuned....
Last edited by bertrandsv87; 12-08-2023 at 08:57 PM.
#9882
#9883
![Default](https://www.rctech.net/forum/images/icons/icon1.gif)
Did you get 186mm with a caliper or some other way ??? I use to read my car's track width on a setup board, but it was way off(by over 1.5mm) my caliper measurements while rotating the tires...
Last edited by bertrandsv87; 12-09-2023 at 02:39 PM.
#9884
![Default](https://www.rctech.net/forum/images/icons/icon1.gif)
I was able to shim the axles with two (0.3) 6mm shims in addition to more wheel shims in order to get to 189mm trackwidth...I guess the mods will have to wait until after the New Year .....lol....Let's go racing !!!!
#9885
![Default](https://www.rctech.net/forum/images/icons/icon1.gif)
The a13W adapters are only 1mm wider, and the hubs are not wide enough, also causing the cvd's to be too short...I have not seen a single A700 with 189mm track width on the internet...Not to mention the cost of all these parts...Solution: Bert mods.....Stay tuned....
i am very impressed with the bert mods. I have several factories in china, ready to produce these wonderful creations. Our staff are all young and motivated, although we have some trouble with Western activists regarding child labour and modern slavery, but all that will pass after a few years when our staff grow older.
we have many modern machines to produce these bert mods made by our founder, who calls his factory machines chan mods. So we will be the best manufacturing provider for your amazing bert mods.
Rest assured, our quality control is very stringent, as we beat and sack any staff who cannot use the chan mods properly. Over time, we have found this to be the best way to ensure quality and skilled staff retention.
Looking froward to working with Mr. Bert. If not, we can always copy what you have anyways.
Mr. Chan
Chan mods and manufacturing