SC10 4x4 Thread
Tech Master
iTrader: (77)
Join Date: Jun 2010
Location: Northern Mexico (aka, El Paso, TX)
Posts: 1,194
Trader Rating: 77 (100%+)
Tech Master
iTrader: (21)
heres my dilemma. there is barely any movement
Tech Master
iTrader: (53)
Tech Master
iTrader: (21)
Tech Master
iTrader: (29)
I just installed a X12 540 6.5 and TC Spec 2, going to try out at track tomorrow. Been using 550 motor from day 1. On the bench looks fast I added some boost and timing, just worry about temps after a pack. Should be ok on a small indoor track.
does anybody know what page where i can find info on how they guys were making the chassis braces?
Tech Master
iTrader: (29)
Www.fastlapproducts.net
Not sure if I should say this but check out below. If its a no no...sry. Just trying to help.
Www.fastlapproducts.net
Www.fastlapproducts.net
Tech Master
iTrader: (29)
Tech Master
iTrader: (29)
I first bought the 3800kv with my mmp. It was fast but I was getting passed and etc.I had 62/13 and I run thunder power lipo. Keep in mind it's not sensored motor. So after doing some homework, I got rx8/pro 4 4000kv sensor wire. It's fast. I'm sure many will agree, I'm not down playing your system. The reason I say that is bc I had that system first. I'm 1000000% sure.
Tech Master
iTrader: (21)
Tech Elite
iTrader: (27)
I first bought the 3800kv with my mmp. It was fast but I was getting passed and etc.I had 62/13 and I run thunder power lipo. Keep in mind it's not sensored motor. So after doing some homework, I got rx8/pro 4 4000kv sensor wire. It's fast. I'm sure many will agree, I'm not down playing your system. The reason I say that is bc I had that system first. I'm 1000000% sure.