motor and esc help.
09-27-2007, 08:19 AM
#1
motor and esc help.
ok i have a brushless motor thats shot and i want to use my ESC with my brushed motor but the colors dont match. the brushed motor has black and red wires and on the esc the black and red wires are the batt wires. there are 3 other wires that are blue yellow and orange. how can i hook these together
the motor i want to use is a peak racing 10x2 motor and the esc is a super sport 10.5 brushless esc
the motor i want to use is a peak racing 10x2 motor and the esc is a super sport 10.5 brushless esc
09-28-2007, 12:31 PM
#2
Tech Initiate
connect the 2 outer wires to the positiveend of the motor and the middle to the negitive end
09-28-2007, 02:41 PM
#4
If all else fails,read the directions
09-28-2007, 04:10 PM
#5
09-28-2007, 04:18 PM
#6
ok i have a brushless motor thats shot and i want to use my ESC with my brushed motor but the colors dont match. the brushed motor has black and red wires and on the esc the black and red wires are the batt wires. there are 3 other wires that are blue yellow and orange. how can i hook these together
the motor i want to use is a peak racing 10x2 motor and the esc is a super sport 10.5 brushless esc
the motor i want to use is a peak racing 10x2 motor and the esc is a super sport 10.5 brushless esc
09-28-2007, 04:41 PM
#7
Tech Initiate
my mamba max esc could use both brushed and brushless and what i wrote erlier is the directions given
09-28-2007, 04:47 PM
#8
09-29-2007, 03:14 AM
#10
Tech Addict
Super Sport 10.5 is the Losi RTR ESC from Novak.
In the Super Sport 10.5 instructions there is no mention of brushed motors. In the Super Sport Plus instructions they tell you to connect the red wire from the battery to one side of the motor and all the brushless motor wires to the other side of the motor. But you have to set up the ESC mode for brushless running and the Super Sport 10.5 manual has no mention of brushed mode.
Based on reading the manual I'd say you can't run brushed motor with your ESC.
If you want to use your speed controller as both brushed and brushless use LRP. LRP ESCs sense how they're connected and switch profiles automatically.
What I'm wondering is how on earth did you manage to "shoot" your brushless motor?
In the Super Sport 10.5 instructions there is no mention of brushed motors. In the Super Sport Plus instructions they tell you to connect the red wire from the battery to one side of the motor and all the brushless motor wires to the other side of the motor. But you have to set up the ESC mode for brushless running and the Super Sport 10.5 manual has no mention of brushed mode.
Based on reading the manual I'd say you can't run brushed motor with your ESC.
If you want to use your speed controller as both brushed and brushless use LRP. LRP ESCs sense how they're connected and switch profiles automatically.
What I'm wondering is how on earth did you manage to "shoot" your brushless motor?
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
